PurePro - Pipe n' Go




	The contractor’s choice

INDIRECT WATER HEATERS






			Sales Sheet/Specs (921KB) Installation Manual (338kb)

The Pipe n’ Go by PurePro combines fast installation with easy servicing. All piping and wiring connections are placed at an easy working height, while sweat unions make plumbing simple. A factory installed T&P and dial aquastat are included with every unit so you can be sure every job is done right.

The tank uses a seamless plastic liner that will not crack, chip or peel. This polyethylene reservoir is surrounded by high-density urethane insulation and enclosed in a steel outer shell with a durable appliance-like finish. The Pipe n’ Go even includes a pre-installed ” turn drain. With this PurePro indirect, you’re ready for any installation; simply Pipe n’ Go.

Removable Heat Exchanger

High-performance in a durable package
Brass plate and cold water inlet pipe provide a strong connection and meet stringent safety codes
Threaded black iron pipe for the boiler supply and return withstand rough handling and require no back-up wrench
Low pressure drop - multiple coil passes allow the use of standard circulator. No large, expensive pump necessary.
Proudly Manufactured in the USA

Features:

Factory installed piping with sweat unions
Control, T & P and drain included with every unit
Reversible design for maximum flexibility
All connections are ” unions
Maximized Heat-Transfer Technology – 8 times faster than cupronickel, 25 times faster than stainless steel
Maximized height/ diameter spacing to create a chimney effect of thermal currents which scrubs more heat into the water faster
High output capabilities to handle larger demands
Available with Limited Lifetime or 6-year Transferable Warranty